Alpes Lasers . TC-3 Manual do Utilizador descarregar pdf (Página 15)

TC-3 Temperature Controller User’s Manual · Page 15

Menu Description Factory

Default

R-High Lim R-High Lim is the sensor high limit. If

operating in R Mode and the actual

sensor measurement exceeds this

value, the output will be turned off. R

limits are not monitored in Ite Mode.

Limit monitoring can also be disabled in

software (see TEC:ENAB:OUTOFF

command).

45kΩ

Tol Time Tolerance time is the amount of time, in

seconds, that the actual temperature

must be within the set point

temperature +/- the Tol Temp value for

the unit to be considered in tolerance.

5 seconds

Tol Temp Tolerance temperature is a temperature

band (in °C) around the set point

temperature. When the actual

temperature is within this band for

longer than the Tol Time setting, then

the unit is considered to be in tolerance.

0.1°C

H/C Mode This selects the heating and/or cooling

mode of the TC-3. See the section

below titled “Resistive Heaters and

Heat/Cool Only Modes” for more

information.

Heat/Cool

Ext Fan This selects the voltage for the auxiliary

fan power supply. See the External Fan

Control section below for more

information.

Off

Ext Fan Pwr When Ext Fan is set to Custom, this

sets the specific fan voltage from 4.0 to

12.0 volts. See the External Fan Control

section below for more information.

12.0

Ext Fan

Mode

Controls when the fan operates. See the

External Fan Control section below for

more information.

Auto

Ext Fan Off When Ext Fan Mode is set to Delay,

this setting defines the number of

minutes to delay turning off the fan

after the TEC output has been turned

off. See the External Fan Control section

below for more information.

5 minutes

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 40 41

Comentários a estes Manuais

Sem comentários

Alpes Lasers . TC-3 Manual do Utilizador Página 15

Comentários a estes Manuais