Alpes Lasers . TC-3 Manual do Utilizador descarregar pdf (Página 8)

Page 8 · TC-3 Temperature Controller User’s Manual

Input Power Connector (IPC)

Once the module has been removed, remove the small, white voltage

selection tumbler from the module, and then re-insert so that the

desired voltage is shown. Re-insert the module into the IPC.

Powering Up the Unit

Once the correct voltage selection has been made, connect the AC

power cord to the unit.

Turn the power switch, located on the front of the unit, into the on (|)

position. The unit will display the current firmware revision, go through

a quick power-up self-test, and return to the last known operating

state.

Ventilation

The TC-3 has vent holes on the rear and left side of the unit. You must

not block these vent holes, or overheating may occur, causing damage

to the unit.

CAUTION

Do not exceed 250VAC on the line input.

It is critical to select the proper voltage selection

prior to applying power to the unit. If the actual

voltage exceeds the voltage selection by +/-10%,

damage to the unit may occur.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 40 41

Sem comentários

Alpes Lasers . TC-3 Manual do Utilizador Página 8